New SOLGW Safety


May 2020 – San Antonio, Texas – Sons of Liberty Gun Works (SOLGW) in collaboration with Forward Controls Design (FCD) set out to create a safety that’s an embodiment of our considerable experience in AR15/M16 selector design and knowledge over the years. This collaboration resulted in the “Quick”.

The Quick was designed from the ground up to be a defense/duty/combat safety selector. Its’ mission is quite aptly reflected by the way its’ levers are attached the center, via a stainless-steel roll pin. The lever to center interface is incredibly strong, the high shear strength (800 lbs) 420 stainless steel spring steel roll pin simply holds the two in place and doesn’t handle any load. One of the design goals dictates there be no wobble between the lever and center, we’ve called for very tight tolerances (+0.001/-0.00) on the Quick’s lever and center interface to achieve that.

The Quick is shipped with a selector spring, a nitrided selector detent, two levers, 4 roll pins (two are needed for installation, with 2 spares).

We do not ship the Quick with one lever installed as we recommend installing the center (dimple forward) and installing the grip, allowing the detent to hold the center in place. Using a vice block to then hold the lower receiver as both levers are installed.

Quick centers are billet machined in 4140, heat treated and black nitrided. Levers are billet machined in 4140 and black nitrided.

Manufactured 100% in the USA.

Available now at


Please enter your comment!
Please enter your name here