Abusing the Gen 3 Pmag

After getting some of the new Pmags as seen in my last review of them, I shot them and decided to  hurt them a little  before I made a final decision.  Behind my house is a 50 foot rock cliff.   I went to the top of the drop and tossed the Mags over the side and had some one throw them back up to me.  Often this resulted in the mag not making it but 3/4 of the way up, then bouncing off the rock face and falling down.  I did this about 20-25 times before my helpers arm got too tired.

OLYMPUS DIGITAL CAMERA

I then took the mag and laid it on the  drive way and dropped a huge piece of fire wood on the mag around 10 times.  I let it fall free not  putting extra effort into throwing it down.

OLYMPUS DIGITAL CAMERA

 

After this, I ran over empty twice with my Jeep. I made sure the front with the engine and the most weight. went over the mag. I then kicked it around for 5 minutes and  dropping it feed lips down onto the drive way from shoulder high  close to 30 times.

The mag then fired  90 rounds fine. It locked back when it was supposed to and it fell free from the mag well just like  you want.   The feed lips did become marred and fuzzy looking ( only way to say it)   but it did not effect performance.  I did note the mag seemed a little harder to load  but not so much to really worry. It is likely grit or something. Or, it is likely just all in my mind. Who knows? I am no scientist so if it keeps working after taking more abuse then reality would deliver, thats good enough for me.

OLYMPUS DIGITAL CAMERA

 

I will not tel you the new gen 3 mag is some huge improvement over the older gen Pmags we all have.  Other then the gripping surface. It is not all the different. It is however. just as tough and reliable as  the other excellent mags they make.  I love Pmags, but I have to tell you again, if you are going to pay a little more for a mag then what the cost of the older Pmag is, go with the Lancer AWM.  But, if you love and trust magpul. you will be more then happy with the Gen 3.  The grip surface is worth an extra buck or two to me.  I do look forward t getting a new ranger plate that will work on the new mags though.

3 thoughts on “Abusing the Gen 3 Pmag”

    1. I did do some of the loaded. Its really the same as any other mag, It vomits up 2- 3 rounds every time it hits the ground. I got tired of hunting the ammo down so unloaded it. No damage was increased from leaving them loaded, so I just didnt bother.

  1. I had hoped to get a few of the Gen 3 just to have and mess with but in the current situation I will be keeping all my “MOE” mags.

Leave a Reply

Your email address will not be published. Required fields are marked *